96 Sweet rack troyer measurements

L

lmsc07ct

Newbie
I am helping my cousin put together his car, it's a 96 sweet rack troyer. We have 137 spindles, slotted 8.5 inch joes uppers, and the adjustable Kluth lowers. Problem is, what ball joints they use, the 772 or the 719? And what lengths am I looking for on the strut rods in the front and the rear clip? Rears a standard troyer setup with the aluminum torque arm, right side panhard, and non quick change.

Need to make this car a roller so I can get my chassis in and out for some off season maintenance. Right now it's blocking the exit. Please help!!
 
K

kt

Champion
772 upper ball joint
719 lower ball joint
21" RF strut
23" LF Strut
17 1/4" rear struts
 
L

lmsc07ct

Newbie
Damn, his lowers are the same as my spafco... I like keeping things a little different!

THANK YOU KT!
what size heims and tubes, 3/4 or 5/8?
 
L

lmsc07ct

Newbie
Thanks again KT... I had been looking for a spafco center section to replace his Chassis Dynamics car after it knocked the clip off. Ended up with a 96 troyer sweet rack car. Local tracks run mostly the CD chassis, easier to find setup help with.

Whats the difference on the 772 and the 719 ball joints? Is the taper the same, just the pin height different? Thanks
 
K

kt

Champion
The tapers are different sizes......The 719 is a beefier ball joint and goes on the bottom.............
 
You must log in or register to reply here.

Top